Reel Enable/Disable Switch - Toro Reelmaster 7000-D Service Manual

Reel Enable/Disable Switch

The reel enable/disable switch is located on the console
arm (Fig. 36). The reel enable/disable switch is an illumi-
nated three (3) position rocker style switch. Push down
on the front of the switch to engage the cutting units
(switch light illuminated) and push down on the rear of
the switch to disengage the cutting units. The reel en-
able/disable switch is an input used by the Toro Elec-
tronic Controller (TEC) to manage various machine
functions.
NOTE: To engage the cutting units, the seat has to be
occupied, the speed limiter has to be in LOW (mow)
speed, and the cutting units have to be fully lowered.
Testing
The reel enable/disable switch and its circuit wiring can
be tested as a TEC input using the InfoCenter Display
(see InfoCenter Display in this chapter). If testing deter-
mines that the switch and circuit wiring are not function-
ing correctly, proceed with the following test procedure:
1. Park machine on a level surface, lower cutting units,
engage parking brake and stop engine. Remove key
from ignition switch.
2. Disassemble console arm to gain access to the reel
enable/disable switch (see Console Arm in Chapter 8 −
Chassis in this manual).
3. Disconnect harness electrical connector from the
reel enable/disable switch.
4. The switch terminals are marked as shown in Figure
37. With the use of a multimeter (ohms setting), the
switch functions can be tested to determine whether
continuity exists between the various terminals for each
switch position. Verify continuity between switch termi-
nals.
5. Replace switch if testing identifies that switch is
faulty.
6. If reel enable/disable switch tests correctly and cir-
cuit problem still exists, check wire harness (see Electri-
cal Schematics and Wire Harness Drawings in Chapter
10 − Foldout Drawings).
7. After testing is completed, connect the wire harness
connector to the reel enable/disable switch.
8. Assemble console arm (see Console Arm in Chap-
ter 8 − Chassis of this manual).
Reelmaster 7000−D
2
MODEL 03780 SHOWN
1. Console arm
SWITCH
POSITION
FRONT OF
SWITCH
PRESSED
NEUTRAL
REAR OF
SWITCH
PRESSED
Page 6 − 41
1
Figure 36
2. Reel enable/disable
switch
BACK OF SWITCH
Figure 37
CLOSED OPEN
CIRCUITS CIRCUITS
2 + 3 2 + 1
5 + 6 5 + 4
NONE ALL
2 + 1 2 + 3
5 + 4 5 + 6
Electrical System