Changing The Fuel-Water Separator Filter; Changing The Engine-Fuel Filter - Toro Reelmaster 7000-D Operator's Manual

Changing the Fuel-Water
Separator Filter
Service Interval: Every 400 hours
1. Drain the fuel-water separator; refer to steps
through 4 in Draining the Fuel-Water Separator
(page 68).
2. Clean the fuel-water separator filter and filter
head (Figure 129).
Figure 129
1. Filter head
3. Remove the separator filter from the filter head.
4. Clean the filter-mounting surface of the filter
head.
5. Apply a coat of clean fuel to the gasket of the
new separator filter.
6. Thread the separator filter into the filter head
until the gasket contacts mounting surface, then
rotate the filter an additional 1/2 turn.
7. Check that the drain valve at the bottom of the
fuel-water separator filter is closed.
8. Start the engine and check for fuel leaks around
the separator filter and filter head.
9. Shutoff the engine, remove the key, close and
latch the hood; refer to
60).
g369850
2. Fuel-water separator filter
Closing the Hood (page
Changing the Engine-Fuel
Filter
Service Interval: Every 400 hours
1 1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood; refer to
59).
3. Clean the area around the fuel-filter head
(Figure 130).
1. Fuel filter
4. Remove the filter and clean the filter-head
mounting surface
5. Lubricate the filter gasket with clean lubricating
engine oil. Refer to the engine owner's manual,
included with the machine, for additional
information.
6. Install the dry filter canister, by hand, until the
gasket contacts the filter head, then rotate it an
additional 1/2 turn.
7. Start the engine and check for fuel leaks around
the filter head.
8. Shutoff the engine, remove the key, close and
latch the hood; refer to
60).
69
59).
Opening the Hood (page
Figure 130
2. Fuel-filter head
(Figure 130).
Closing the Hood (page
g369851