Control System Warnings - GE Mark VIeS System Manual

Control System Warnings

Warning
Warning
Warning
Warning
Warning
To prevent personal injury or damage to equipment, follow all equipment safety
procedures, Lockout Tagout (LOTO), and site safety procedures as indicated by
Employee Health and Safety (EHS) guidelines.
This equipment contains a potential hazard of electric shock, burn, or death. Only
personnel who are adequately trained and thoroughly familiar with the equipment
and the instructions should install, operate, or maintain this equipment.
Isolation of test equipment from the equipment under test presents potential electrical
hazards. If the test equipment cannot be grounded to the equipment under test, the
test equipment's case must be shielded to prevent contact by personnel.
To minimize hazard of electrical shock or burn, approved grounding practices and
procedures must be strictly followed.
To prevent personal injury or equipment damage caused by equipment malfunction,
only adequately trained personnel should modify any programmable machine.
Always ensure that applicable standards and regulations are followed and only
properly certified equipment is used as a critical component of a safety system. Never
assume that the Human-machine Interface (HMI) or the operator will close a safety
critical control loop.
Public Information
GEH-6855_Vol_II System Guide 5