Signal Space Inputs For Sensor Types, With Firmware Version 5.0; System Limits - GE Mark VIeS System Manual

8.3.2.1 Signal Space Inputs for Sensor Types, with Firmware Version 5.01 or Later
Sensor Type GAPn_VIBn
Inputs 1-8
PosProx
Inputs 1-8
VibProx
Inputs 1-8
VibProx-KPHx
Inputs 1-8
VibLMAccel
Inputs 1-8
VibSeismic
Inputs 1-8
VibVelomitor
Unused (H1A)
CDM_BN_ChgAmp
Inputs 1-8
(H1B Only)
(H1B)
Unused (H1A)
CDM_PCB_ChgAmp
Inputs 1-8
(H1B Only)
(H1B)
KeyPhasor
n = input number

8.3.2.2 System Limits

GAP, VIB, and LM 1x Tracking Filters each support System Limits for configurable limit checking. This function returns a
Boolean value indicating whether the limit has been exceeded, with optional latching behavior. This function is intended to
simplify application logic by moving common functionality into the YVIB configuration.
All system limits are implemented the same way, regardless of which input we are describing. System limits checks are
executed at Frame Rate, on the value in signal space after it has been converted to the correct units. Based on the
configuration, the system limits check will behave as greater than set point (>=) or less than set point (<=), and the result can
be latching or non-latching. System Limit latches are SET dominant, so the results of the checks will be TRUE as long as the
signal exceeds the set point.
Note Latching system limits are reset using the RSTSYS pin on the SYS_OUTPUTS block.
YVIB Vibration Monitor Modules
GAP12_KPH2
GAPn_POSy
GAP13_KPH1
(y = 1-3)
Inputs 9-11 Inputs 12-13
Inputs 13 (H1A)
Inputs 12-13
(H1B)
Public Information
VIB_1Xn
Vib1xPHn
VIBn
VIB_2Xn
Vib2xPHn
Inputs 1-8
Inputs 1-8 Inputs 1-8
Inputs 1-8
Inputs 1-8
Inputs 1-8
Unused (H1A)
Inputs 1-8
(H1B)
Unused (H1A)
Inputs 1-8
(H1B)
GEH-6855_Vol_II System Guide 237
LMVibnA
LMVibnB
LMVibnC
Inputs 1-3
Unused (H1A)
Inputs 1-3 (H1B)
Unused (H1A)
Inputs 1-3 (H1B)
Unused (H1A)
Inputs 1-3 (H1B)
Unused (H1A)
Inputs 1-3 (H1B)