Probe Nominal Settings - GE Mark VIeS System Manual

8.3.4.2 Variables
Variables Description
L3DIAG_YVIB_x I/O Pack Diagnostic Indicator where R, S, or T is the redundancy of pack
LINK_OK_YVIB_ IONet Link Okay Indicator where R, S, or T is the redundancy
x
ATTN_YVIB_x I/O Pack Status Indicator where R, S, or T is the redundancy
PS18V_YVIB_x I/O Pack 18 V Power Supply Indication where R, S, or T is the redundancy
PS28V_YVIB_x I/O Pack 28 V Power Supply Indication where R, S, or T is the redundancy
IOPackTmpr_ I/O Pack Temperature at the processor where R, S, or T is the redundancy
RPM_KPH1 Speed (RPM)of KP#1,calculated from input#13
LM_RPM_A Speed A(RPM), calculated externally to the I/O Pack
LM_RPM_B Speed B(RPM), calculated externally to the I/O Pack
LM_RPM_C Speed C(RPM), calculated externally to the I/O Pack
SysLim1GAPx Boolean set TRUE if System Limit 1 exceeded for Gap x input
where x = 1 to 13
SysLim2GAPx Boolean set TRUE if System Limit 2 exceeded for Gap x input
where x = 1 to 13
SysLim1VIBx Boolean set TRUE if System Limit 1 exceeded for Vib x input
where x = 1 to 8
SysLim2VIBx Boolean set TRUE if System Limit 2 exceeded for Vib x input
where x = 1 to 8
SysLim1ACCx Boolean set TRUE if System Limit 1 exceeded for Accelerometer x input
where x = 1 to 9
SysLim2ACCx Boolean set TRUE if System Limit 2 exceeded for Accelerometer x input
where x = 1 to 9

8.3.4.3 Probe Nominal Settings

Probe Type
Proximity
Seismic
Velomitor
Accelerometer
Keyphasor
Bently Nevada CDM
PCB CDM
†
These are the default settings used if GnBiasOvride=Disable.
YVIB Vibration Monitor Modules
Gain † Snsr_Offset (Vdc)
1x 9
4x 0
2x 12
2x 10
1x 9
2x 10
2x -12
Public Information
Direction and
Datatype
Input BOOL
Input BOOL
Input BOOL
Input BOOL
Input BOOL
Input BOOL
Analog Input REAL
Analog Output REAL
Analog Output REAL
Analog Output REAL
Input BOOL
Input BOOL
Input BOOL
Input BOOL
Input BOOL
Input BOOL
Scale (typical value)
200 mv/mil
150 mv/ips
100 mv/ips
150 mv/ips
200 mv/mil
170 mv/psi
170 mv/psi
GEH-6855_Vol_II System Guide 263