Kph - GE Mark VIeS System Manual

8.3.4.11 KPH

[ ] = defaults
†
is only valid with YVIBS1B
Name Direction
GAP12_KPH2 AnalogInput
GAP13_KPH1 AnalogInput
KPH_Type GnBiasOvr-
ide
[Slot], Gain Bias
Pedestal Override
[Disable],
Enable
‡ Gain 2x and Gain 8x are Never valid on GAP12_KPH2.
SysLim2Enabl
Enable System Limit 2
[Disable], Enable
YVIB Vibration Monitor Modules
Data Description
Type
REAL Average Air Gap,DC
component of input#9
REAL Average Air Gap,DC
component of
input#10
Snsr_Offset Gain
Amount of bias Resolution of
voltage (dc) to input signal
remove from input (net gain
signal used to unchanged),
max. A/Ds signal select based
range used only on expected
when range, use
GnBiasOvride is only if
enabled GnBiasOvride
[10] is enabled
±13.5 [1x], ‡ 2x, 4x,
8x
SysLim2Latch
Latch the alarm
[Latch], NotLatch
Public Information
VIB_Type3 Scale Scale_Off
Sensor Type,
group 3
Scale
[Unused],
Volts/- offset for
†
PosProx,
mil or Prox
KeyPhasor
Volt- position
s/ips only, in
Sensor Type,
[0.2] mils
group 3
0 to 2 [0]
[Unused],
0 to 90
PosProx,
KeyPhasor
SysLim1E- SysLim1-
nabl Latch
Enable System Latch the
Limit 1 alarm
[Disable], [Latch],
Enable NotLatch
‡
SysLim2Type
System Limit 2 Check Type
[ >= ] , <=
TMR_ KPH_Thrshld
DiffLimit
Voltage
Difference difference from
Limit for Voted gap voltage
TMR Inputs in where
Volts or Mils keyphasor
[2] triggers
-100 to 100 [2.0]
1.0 to 5.0
SysLim1Type SysLimit1
System Limit 1 System
Check Type Limit 1 –
[ >= ] , <= GAP in
negative
volts
(Velomitor)
or positive
mils (Prox)
[90]
-100 to 100
SysLimit2
System Limit 2 – GAP in
negative volts (Velomitor) or
positive mils (Prox)
[10]
-100 to 100
GEH-6855_Vol_II System Guide 269