Installing Monitoring Devices; Optional) Installing Ecc800 Accessories - Huawei FusionModule1000A20 Installation Manual

FusionModule1000A20 Prefabricated All-in-One Data
Center
Installation Guide

6.4 Installing Monitoring Devices

This manual does not cover the installation of upstream monitoring devices. For the detailed
installation methods, see iManager NetEco Product Document - (NetEco Version).

6.4.1 (Optional) Installing ECC800 Accessories

Prerequisites
Required ECC800 accessories have been obtained.
Preparations
Tools: Phillips screwdriver
Materials: Micro SD card, SIM card, 4G antenna, RF_Z antenna
The SIM card needs to support Global System for Mobile Communications (GSM) and
Wideband Code Division Multiple Access (WCDMA).
Skill requirement: common technician
Procedure
Step 1 (Optional) Remove the ECC800 main control module and install the SIM card and SD card
inin the corresponding slot side if SIM card and SD card are required.
1.
2.
3.
Issue 02 (2020-01-15)
Loosen the screws on both sides of the ECC800 main control module.
Pull the handles on both sides of the ECC800 main control module, and remove the main
control module.
Figure 6-24 Removing the ECC800 main control module
Install the Micro SD and SIM card in the corresponding slot of the ECC800 main control
module.
Copyright © Huawei Technologies Co., Ltd.
6 Installing Devices Inside the Pre-fab. Module
58