Installing An External Horn Strobe - Huawei FusionModule1000A20 Installation Manual

FusionModule1000A20 Prefabricated All-in-One Data
Center
Installation Guide
Figure 6-36 Connecting the reserved battery cable
----End

6.5.4 Installing an External Horn Strobe

Prerequisites


preparing for the Installation
Tools: Phillips screwdriver, step ladder
Materials: external horn strobe and its screws
Skill requirement: common technician
Procedure
Step 1 Remove the sealing plate from the installationposition of the horn strobe.
Step 2 Install the horn strobe cover.
Issue 02 (2020-01-15)
The pre-fab. modules have been installed.
The position for installing the horn strobe has been specified.
Use sealant to seal the screw holes left after the sealing plate is removed.
Copyright © Huawei Technologies Co., Ltd.
6 Installing Devices Inside the Pre-fab. Module
68