Extended Parameters; Setting Ftp Parameters - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
Figure 7-55 Setting IEC104 parameters

7.10.3 Extended Parameters

7.10.3.1 Setting FTP Parameters

The FTP function is used to access a third-party NMS. The SmartLogger can report the
configuration information and running data of the managed plant system through FTP. A
third-party NMS can access Huawei devices after being configured.
Because of permission restriction, log in as Advanced User. Choose Settings > FTP to
access the target page.
Issue 04 (2018-04-10)
 IEC104 is a general standard protocol without a security authentication mechanism. To reduce
network security risks, the function of connecting to a third-party NMS using IEC104 is disabled by
default. To use this function, set Link setting to Enable. To use this function, set Link setting to
Enable(Limited) or Enable(Unlimited). If you select Enable(Limited), the SmartLogger can
communicate with up to five third-party NMSs whose IP addresses are set under IEC104. If you
select Enable(Unlimited), the SmartLogger can communicate with all third-party NMSs with valid
IP addresses.

You can click the Select icon in the upper left corner of the page to access the required setting page.
 You can export an IEC104 configuration file in CSV format.
After the IEC104 configuration file exported from the SmartLogger and the device type IEC104
information files delivered with devices are correctly configured on a third-party NMS, the
third-party NMS will be able to monitor the devices connected to the SmartLogger over the IEC104
protocol.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
158