Port Settings; Setting Do Parameters - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
Figure 7-57 Setting email parameters

7.10.4 Port Settings

7.10.4.1 Setting DO Parameters

Context
The SmartLogger provides three DO ports. Connect one DC power cable of the 3G router to
one of the DO ports, and power on and off the wireless module by disconnecting and
connecting the DO dry contact to control the reset of the 3G router.
Considering the restrictions on the current that can pass through the DO port of the
SmartLogger, you need to determine the number of DO ports to be used for the control based
on the maximum power supply current of the 3G router (the maximum power supply current
can be calculated based on the maximum power consumption and DC power supply voltage).
When the power supply current is less than 0.5 A and the voltage is lower than 12 V, use one
DO port.
Issue 04 (2018-04-10)
 SMTP Server can be set to the domain name or IP address of the SMTP server.
If it is set to the domain name of the SMTP server, ensure that the address of the DNS server is set
correctly.
 Set Encryption mode to encrypt the mails. Currently, the following types of mail addresses support
encryption: Outlook, @qq.com, @126.com, @163.com, and @sina.com, of which only Outlook
supports TLS encryption.
 SMTP Port specifies the port used for sending emails.

User name and Password specify the user name and password used for logging in to the SMTP
server.
 Send address specifies the sender's email address. Ensure that the sender's email server is the same
as the server specified by SMTP server.
 You can click Send test mail to check whether the SmartLogger can successfully send emails to
users.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 WebUI
160