Logging In To The Webui - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
Step 5 Set Security level for this zone to Medium or Low.
----End

7.3 Logging In to the WebUI

Context
The SmartLogger has been connected to a PC directly or over the Ethernet. For details, see
4.11 Connecting an Ethernet Network
If you log in to the WebUI for the first time, a security risk warning shown in
displayed. Click Continue to this website. to continue the WebUI login.
Figure 7-5 Security risk warning
Procedure
Step 1 Enter https://XX.XX.XX.XX in the address box of the browser, and press Enter. The login
page is displayed.
Issue 04 (2018-04-10)
The IP address of the SmartLogger can be obtained as follows:

When logging in to the app for the first time, obtain information including IP address from
Ethernet under Quick Settings.
 When logging in to the APP subsequently, choose Settings > Comm. Param > Ethernet to view the
information.
 To restore the IP address to the default IP address, press and hold down the Default key for more
than 10s until the RUN indicator blinks at short intervals (0.125s on and 0.125s off) and all other
indicators are off, and then release the Default key. The operation is valid within 5 minutes.

It is recommended that users use their own certificates. If the certificate is not replaced, the security
risk warning will be displayed during each login.
 After logging in to the WebUI, you can import a certificate under Network Security Certification
on the 7.11.3 Setting Security Parameters
 The imported security certificate needs to be bound to the SmartLogger IP address. Otherwise, the
security risk warning will still be displayed during login.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Cable.
page.
7 WebUI
Figure 7-5
86