Page 1
2.0-CIM01C2 User Manual Issue Date 2019-01-02 HUAWEI TECHNOLOGIES CO., LTD.
Page 2
Notice The purchased products, services and features are stipulated by the contract made between Huawei and the customer. All or part of the products, services and features described in this document may not be within the purchase scope or the usage scope. Unless otherwise specified in the contract, all statements, information, and recommendations in this document are provided "AS IS"...
About This Document About This Document Purpose This document describes the iBAT 2.0-CIM01C2, the intelligent battery monitoring system in a data center, in terms of its features, installation, networking, and maintenance. Figures used in this document are for reference only.
When operating Huawei equipment, strictly follow the precautions and safety instructions. The safety precautions given in this document do not cover all the safety precautions. Huawei will not be liable for any consequence caused by the violation of the safety operation regulations and design, production, and usage standards.
AC mains supply, which stated in instruction. 1.3 Basic Installation Requirements The iBattery for data centers can be commissioned and maintained only by Huawei engineers or engineers certified by Huawei. Otherwise, personal injury or equipment damage may occur. Huawei equipment can be installed, operated, and maintained only by persons who have been trained on safety precautions and have mastered the correct methods.
Ambient temperature The ambient temperature Find the cause of an monitoring should be lower than 45° C. abnormal temperature. If the fault persists, contact Huawei technical support. 9.1.2 Quarterly Maintenance Table 9-2 Routine maintenance items Item Expected Result Troubleshooting Battery management Check that the battery Set parameters correctly.
Batt. abnormal BCB trip are set to Enable in the UPS MDU, when a Single Batt. terminal off alarm is raised, the system automatically controls the BCB to disconnect. If the fault persists, contact Huawei technical support. 9.3 Component Replacement 9.3.1 Replacing a CIM Prerequisites ...