Connecting An Ethernet Network Cable - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual

4.11 Connecting an Ethernet Network Cable

Context


Procedure
Step 1 Connect one end of the delivered network cable to the Ethernet electrical port of a device.
Step 2 Connect the other end of the network cable to ETH1 or ETH2 of the SmartLogger.
Figure 4-27 Connecting an Ethernet network cable
----End
Issue 04 (2018-04-10)
The SmartLogger provides two Ethernet electrical ports, through which the SmartLogger
can connect to a third-party device.
The SmartLogger can be connected to an Ethernet switch, router, or POE module. It can
also be connected to the Ethernet electrical port of a PC directly or through a hub. Select
the device to be connected based on the actual networking scenario. For details on
typical scenarios, see 2.4 Typical Networking
If the delivered cable is too short, pay attention to the following when preparing a cable:
 Select a CAT 5E or higher-class shielded network cable.

The cable length should not exceed 100 m.
 A POE module needs to be connected to the DATA port of the SmartLogger.
 The default IP address of the SmartLogger is 192.168.0.10, the default subnet mask is 255.255.255.0,
and the default gateway is 192.168.0.1.
 If the SmartLogger is connected to a PC directly or through a hub, set the IP addresses of the
SmartLogger and PC in the same network segment. For example, if the IP address of the
SmartLogger is 192.168.0.10, set the IP address of the PC to 192.168.0.11. The subnet mask and the
gateway of the PC should be consistent with those of the SmartLogger.

If the SmartLogger is connected to a PC through a networking device (such as a router), set the IP
addresses of the SmartLogger and networking device in the same network segment. Set the gateway
of the SmartLogger correctly so that it can communicate with the networking device.
 To enable communication between the SmartLogger and the NetEco, set NetEco parameters
properly on the SmartLogger. For details, see
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Scenarios.
7.10.2.4 Setting NetEco Parameters.
4 Electrical Connection
69