Device List; Exporting Parameters - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual

7.11.8.2 Device List

Because of permission restriction, log in as Advanced User or Special User. Choose
Maintenance > Device list to access the target page.
Figure 7-79 Device list

7.11.8.3 Exporting Parameters

Because of permission restriction, log in as Advanced User or Special User. Choose
Maintenance > Export Param. to access the target page.
Issue 04 (2018-04-10)
 Before manually adding a slave SmartLogger, set the Modbus TCP parameters correctly. Set Link
setting to Enable and enter the IP address of the slave SmartLogger in Client IP address. For
details, see 7.10.2.5 Setting Modbus TCP
Device Type to SmartLogger and enter the IP address of the slave SmartLogger in IP address.

When connecting a third-party device, import a configuration file for the device, and then manually
add the device.

An accessed device can be removed manually, and a removed device can be added again.
 Auto Assign Address allows you to adjust device addresses based on serial numbers. If a device
cannot access due to address conflict, perform this operation to assign a new device address and then
access the device.
 After the device is connected, you can export the device configuration. When changing the name of
the exported file, retain the extension .cfg. Otherwise, the file cannot be functional.
 You can click the Start, Stop, or Reset icon to send the corresponding command to all inverters
connected to the SmartLogger. The login password is required if you need to send a command.
You can modify the device name and address on the WebUI, or export a device information file in CSV
format and import the CSV file into the WebUI after modification.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Parameters. When adding the slave SmartLogger, set
7 WebUI
180