Huawei SmartLogger2000 User Manual page 146

SmartLogger2000
User Manual
Figure 7-33 Setting running parameters
Table 7-10 Parameter description
No. Parameter
1 Offset mode
2 Output
enabled
Issue 04 (2018-04-10)
The parameter list provided in this document includes all configurable parameters. Configurable
parameters vary depending on the device model. The actual display prevails.
Function Value
Specifies the offset Disabled
mode of the PID
N/PE
module.
PV/PE
Automatic
Specifies whether Enable
PID module output
Disable
is enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Select Disabled if the PID module is not required.

PID01: Select N/PE if the PID module is
required to use voltage output from the inductor
virtual midpoint.

SmartPID2000: Select N/PE if the PID module is
required to use voltage output from the power
grid.
 PID01: Select PV/PE if the PID module is
required to use voltage output from the negative
PV terminal. This mode is applicable only to
Huawei SUN8000.
 SmartPID2000: N/A

PID01: For the inverter, Automatic indicates the
N/PE offset mode.
 SmartPID2000: N/A
Select Enable to enable the PID module output.
Select Disable to disable the PID module output.
7 WebUI
136