Setting Initialization Parameters - Huawei SmartLogger1000 Quick Manual

11

Setting Initialization Parameters

When starting the SmartLogger for the first time, set initialization parameters such as the system
language, system time, the address search scope for the RS485 port, and Ethernet parameters on
the monitoring panel.
12
12
FAQ
The SmartLogger cannot be powered on.
12.1
1. Check that the power cable connects to the power adapter.
2. Check that the power cable connects to the AC socket.
3. Replace the power adapter.
4. Contact the vendor or Huawei technical support.
12.2
The SmartLogger cannot find devices.
1. Check the RS485 communications cable connection. If the cable is loose, disconnected, or
reversely connected, reconnect and secure it.
2. Check the RS485 communication parameter settings on the SmartLogger and ensure that the baud
rate and communication address are set correctly.
3. Manually add the devices that cannot be detected automatically, such as the EMI and power meter.
4. Ensure that the EMI parameters are set correctly.
5. Set the SUN2000 address to be within the search address range set for the SmartLogger.
6. Contact the vendor or Huawei technical support.
NOTE
1. This document uses the LCD screenshots of SmartLogger
V100R001C00SPC109 as an example.
2. After the date and time are set, the date and time of all the inverters
connecting to the SmartLogger are synchronized. Therefore you
need to ensure that the settings are correct.
3. On the Ethernet screen, set the SmartLogger IP address according
to the rules of the power station and ensure that it differs from any
device IP address.
4. Visiting some menus requires account authentication. Therefore,
change the password immediately after setting initialization
parameters to ensure the security of your account.
15