ABB IRC5 Compact Product Manual page 49

B
Connections to ports may be done as detailed below.
Connection to/from:
Connecting the IRC5 Compact to the fact-
ory LAN.
Connecting a PC to the IRC5 Compact
service port.
Connecting a PC to the service port
1
2
3
4
5
3HAC035738-001 Revision: E
LAN port (connects to factory LAN)
Action
Make sure the network setting on the PC
to be connected is correct.
Use the delivered category 5 Ethernet
crossover boot cable with RJ45 connect-
ors.
Connect the boot cable to the network port
of your PC.
Remove the thumb screw and open the
cover on the front panel of the controller.
Connect the boot cable to the service port
on the controller.
© Copyright 2009-2013 ABB. All rights reserved.
2 Installation and commissioning
2.6.3 Connecting a PC to the service port
Detailed in section:
Proceed as detailed below.
Illustration
Refer to the system documentation for your
PC, depending on the operative system
you are running.
The PC must be set to "Obtain an IP ad-
dress automatically" or set as described
in Service PC Information in the Boot Ap-
plication.
The cable is delivered in the RobotWare
product box.
xx0900000268
• A: thumb screw
xx0900000269
• A: Service port
Continued
49