ABB IRC5 Compact Product Manual page 104

4 Repair
4.4 Replacement of backup energy bank
Continued
Removal
The following procedure describes how to remove the backup energy bank.
1
2
3
4
5
6
7
Refitting
The procedure below details how to refit the backup energy bank.
1
2
Continues on next page
104
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety informa-
tion in section DANGER - Make sure that the
main power has been switched off! on
page 29.
Remove the top cover of the cabinet.
Remove the left and right side covers of the
cabinet.
Lift the middle layer of the cabinet and se-
cure it.
Disconnect the connector X7 from the power
distribution board.
Remove the attachment screws.
Pull out the backup energy bank.
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety informa-
tion in section DANGER - Make sure that the
main power has been switched off! on
page 29.
Refit the new backup energy bank.
© Copyright 2009-2013 ABB. All rights reserved.
Note/illustration
See Removing the top cover on page
See Removing the left side cover on
page 67 and Removing the right side
cover on page 68.
See Lifting the middle layer on page
xx0900000547
• A: Backup energy bank
• B: connector
• C: attachment screws
Note/illustration
3HAC035738-001 Revision: E
67.
69.