ABB IRC5 Compact Product Manual page 137

2
3
4
5
6
7
8
Refitting
Use the following procedure to refit the line filter.
1
3HAC035738-001 Revision: E
Action
CAUTION
Hot surface on top of the bleeder.
Risk of burns. Be careful when
removing the unit.
Remove the fan cover.
Remove the top cover of the
cabinet.
Disconnect the bleeder connect-
or from the drive unit and get the
bleeder cable out of the back
cover of the cabinet through the
hole.
Loosen the two lower attachment
screws on the bleeder bracket.
Remove the upper attachment
screw.
Pull the brake resistor bleeder
upwards and then outwards, to
release it from the upper screw
heads, and remove it.
Action
DANGER
Before commencing any work
inside the cabinet, please ob-
serve the safety information in
section DANGER - Make sure
that the main power has been
switched off! on page 29.
© Copyright 2009-2013 ABB. All rights reserved.
4.14 Replacement of brake resistor bleeder
Note/illustration
xx0900000599
• A: upper attachment screw
• B: lower attachment screws
Note/illustration
4 Repair
Continued
Continues on next page
137