Samsung CLX-9350ND Service Manual page 430

● Code :
M3-2230
● Symptom / Cause :
Too much paper in output bin tray (paper out put secti
- The bin full sensor actuator or sensor is defective.
● Troubleshooting method :
1. Remove the exit unit from the set. And replace the f
2. Enter the diagnostic mode, and execute the face do 2. Enter the diagnostic mode, and execute the face do
When lifting the bin full actuator, if "without paper" is
reconnect the connector.
3. If the photo interrupter is broken away from the exit
interrupter.
4. Check if the photo interrupter connector, junction co
If the connector is unplugged, remove exit unit and r
5. Check if the regi connector on the engine controller
Reconnect it.
6. Replace the engine controller PBA. 6. Replace the engine controller PBA.
● Replacement part
- JC90-00914A : EXIT (CLX-9350ND)
- JC90-00914B : EXIT (CLX-9250ND)
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7. Troubles shooting
● Error message :
Output tray (face dow wn) is full. Remove printed media.
ion)
face down antistatic brush.
wn bin full sensor test. wn bin full sensor test.
s displayed, replace the photo interrupter or
unit, remove the exit unit and reassemble the photo
onnector are connected properly.
reconnect the connector.
( )
7-9 90
is connected properly.
SAMSUNG ELECTRONICS