● Code :
H1-1322
H1-1422
M1-3122
M1-3222
● Symptom / Cause :
Tray No. LED is on.
- Tray 1 (2,3,4) is pulled out or the auto size sensor co
● Troubleshooting method :
1. Insert the corresponding cassette perfectly.
2. If the cassette is not locked or pulled out without hol
3. Check if the auto size sensor is connected properly.
4. Check if the connector on the Joint PBA is connecte
5. Replace the engine controller PBA.
● Replacement part
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7. Troubles
shooting
● Error message :
Tray 3 is pulled out.
Insert it properly.
Tray 4 is pulled out.
Insert it properly.
Tray 1 is pulled out.
Insert it properly.
Tray 2 is pulled out.
Insert it properly.
onnector is not connected or broken.
lding the locking lever, reassemble the cassette.
. Reconnect or replace it.
ed properly. Reconnect or replace it.
7-7
71
SAMSUNG ELECTRONICS