Heat Roller - Samsung CLX-9350ND Service Manual

3.5.8 Heat roller

Perform the following procedure to remove the Heat R
1. Remove the Halogen lamp (Refer to 3.5.4) 1 R th H l
2. Remove the shaft PR screw [A], 4 screws, and
connector on EEPROM.
3. Release the Holder EEPROM[E] after removing 1
screw.
4. Remove the Bracket [B].
[B] [B]
[E]
5. Remove the bracket [F] after removing 1 screw.
CAUTION
The ends of springs is sharp. Be careful not hurt
yourself.
Do not pull the spring by too strong. If the spring is
damaged, the heat roller can not rotate. It can
damage the belt overheat and make a fire damage the belt, overheat and make a fire.
Service Manual
CLX-9250/9350 series
3. Replacemen
l (R f t 3 5 4)
[A]
[F]
nt Procedures
Roller from the Fuser Unit.
6. Remove the Holder lamp [C] after removing 3 6 R th H ld
screws.
7. Remove 2 screws and 2 springs.
8. Remove the bracket [D].
[D]
3-3 39
l [C] ft i
[C]
p g
SAMSUNG ELECTRONICS
3