Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 491

4.
Calibration parameter selection
Turn
5.
Selecting the parameter
Turn
(Pr.933) Terminal 4 gain (torque)) for terminal 4.
6.
Analog voltage (current) display
Press
Do not touch
7.
Voltage (current) application
Apply a 5 V (20 mA). (Turn the external potentiometer connected between terminals 1 and 5 (terminals 4 and 5) to
a desired position.)
8.
Setting completed
Press
alternately.
• Turn to read another parameter.
• Press to return to the "
• Press twice to show the next parameter.
 Adjustment by selecting the voltage (current) at the bias/gain torque without applying voltage
(current) between terminals 1 and 5 (4 and 5)
Operating procedure
1.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
2.
Changing the operation mode
Press
3.
Selecting the parameter setting mode
Press
4.
Calibration parameter selection
Turn
5.
Selecting the parameter
Turn
(Pr.933) Terminal 4 gain (torque)) for terminal 4.
6.
Analog voltage (current) display
Press
7.
Analog voltage (current) adjustment
When
Turn
490
5. PARAMETERS
5.12 (T) Multi-function input terminal parameters
until " " appears. Press
until " " (C19 (Pr.920) Terminal 1 gain (torque)) appears for terminal 1, or "
to display the analog voltage (current) % currently applied to the terminal 1 (4).
until calibration is completed.
to confirm the selection. The analog voltage (current) % and "
" display.
to choose the PU operation mode. [PU] indicator turns ON.
to choose the parameter setting mode. (The parameter number read previously appears.)
until " " appears. Press
until " " (C19 (Pr.920) Terminal 1 gain (torque)) appears for terminal 1, or "
to display the analog voltage (current) % currently applied to the terminal 1 (4).
is turned, the gain voltage (current) value (%) currently set to the parameter appears.
until the desired gain voltage (current) value (%) appears.
to display " ".
to display " ".
" (C41
" (" ") are displayed
" (C41