Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 144

NOTE
• " " appears if the Pr.79 setting is tried to be changed while the inverter is set that only the parameters registered in
the user group are read (Pr.160 = "1") but Pr.79 is not included in the user group.
• " " appears if a setting change is attempted during inverter operation. Turn OFF the start command (
, or STF/STR signal).
• If is pressed before pressing
mode. If the easy setting is terminated while Pr.79 = "0 (initial value)", check the inverter operation mode because the inverter
may switch its operation mode between the PU operation mode and the External operation mode.
• Reset by pressing
• The priorities of the frequency commands while Pr.79 = "3" are "Multi-speed operation (RL/RM/RH/REX) > PID control (X14)
> terminal 4 analog input (AU) > digital input from the operation panel".
, the easy setting is terminated and the operation panel returns to the monitor
is enabled.
4. BASIC OPERATION
4.3 Easy setting of the inverter operation mode
1
/
2
3
4
5
6
7
8
9
10
143