Huawei SmartLogger2000 User Manual page 23

SmartLogger2000-(10-C, 11-C)
User Manual

The general single-phase input power cable for the smart array controller needs to be
prepared by the customer. You are advised to use a two-core armor copper cable with an
operating voltage to the ground greater than or equal to 300 V and a cross-sectional area of
4 mm

The power cable from the miniature circuit breaker (MCB) to the station-service power
source needs to be prepared by the customer. You are advised to use a two-core armor
copper cable with an operating voltage to the ground greater than or equal to 300 V and a
cross-sectional area of 4 mm

The PLC three-phase input power cable for the smart array controller needs to be prepared
by the customer. You are advised to use a three-core armor copper cable with an operating
voltage greater than or equal to 1000 V and a cross-sectional area of 10 mm
wire. Connect this cable only in the PLC networking scenario.

The cable from the busbar to the knife fuse switch needs to be prepared by the customer.
You are advised to use a three-core, multi-strand armor cable with an operating voltage to
the ground greater than or equal to 1000 V and a cross-sectional area of 10 mm
core wire. Connect this cable only in the PLC networking scenario.
Figure 2-9 Fiber+RS485/PLC
Issue Draft A (2017-02-15)
2
for each core wire.
2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
for each core wire.
2 Product Overview
2
for each core
2
for each
15