Huawei SmartLogger2000 User Manual page 101

SmartLogger2000-(10-C, 11-C)
User Manual
No. Parameter Description
8 Crystalline This parameter
silicon PV reduces the DC
compensati voltage of PV
on mode modules to the PE by
reducing the
impedance of the
SUN2000 input side
to the PE, thereby
effectively reducing
PID effect of PV
modules.
9 Communic The standards of
ation certain countries and
interrupt regions require that
shutdown the SUN2000 must
shut down after the
communication is
interrupted for a
certain time.
10 Communic Specifies the duration
ation for determining
interruptio communication
n duration interruption, and is
used for automatic
shutdown for
protection in case of
communication
interruption.
Communic If this parameter is
11
ation enabled, the
resumed SUN2000
startup automatically starts
after communication
recovers. If this
parameter is disabled,
the SUN2000 needs to
be started manually
after communication
recovers.
Issue Draft A (2017-02-15)
Default
Unit
Value
N/A Output
disabled
N/A Disable
min 30
N/A Enable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value Range Remarks
 Output This parameter is
disabled displayed if PV
module type is set
 P-type output
to Crystalline

N-type
silicon. Set this
output
parameter to P-type
output for P-type
PV modules and
N-type output for
N-type PV modules.
 Disable If Communication
interrupt shutdown
 Enable
is set to Enable and
the SUN2000
communication has
been interrupted for
a specified time (set
by Communication
interruption
duration), the
SUN2000 will
automatically shut
down.
[1, 120] -

Disable N/A

Enable
7 WebUI
93