Environmental Conditions; Installation Orientation - Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual

14. SERVO MOTOR

14.4.1 Environmental conditions

Environment
Ambient temperature
Ambient humidity
Storage temperature
Storage humidity
Ambient
Altitude
[m/s ]
2
(Note)
Vibration
[ft/s ]
2
Note: Except the servo motor with reduction gear.
Vibration occurs in the directions shown below.
The values were measured at the portion which
indicates the maximum value (normally the
bracket opposite to load side). When the servo
motor is at a stop, the bearings are likely to fret
and vibration should therefore be suppressed to
about half of the permissible value.
X
Vibration

14.4.2 Installation orientation

The following table lists directions of installation:
Servo Motor Series
HC-KFE
HC-SFE
When the servo motor with electromagnetic brake is installed with the shaft end at top, the brake plate
may generate sliding sound but it is not a fault. Refer to Section 14.6.3 for the installation orientation of
the servo motor with reduction gear.
[ ] 0 to 40 (non-freezing)
[ ] 32 to 104 (non-freezing)
80%RH or less (non-condensing)
[ ] 15 to 70 (non-freezing)
[ ] 5 to 158 (non-freezing)
90%RH or less (non-condensing)
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Max. 1000m (3280ft) above sea level
HC-KFE series
HC-SFE52 to 152
HC-SFE202
HC-KFE series
HC-SFE52 to 152
HC-SFE202
Servo motor
Y
Direction of Installation
May be installed in any
direction.
Conditions
Graph of vibration servo amplitude vs. speed
200
100
80
60
50
40
30
20
500
For installation in the horizontal direction, it is recommended to set the
connector section downward.
14 - 6
X,Y:49
X,Y:24.5
X:24.5
Y:49
X,Y:161
X,Y:80
X:80
Y:161
1000 1500 2000 2500 3000 3500
Speed [r/min]
Remarks