Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual page 184

13. OPTIONS AND AUXILIARY EQUIPMENT
(2) Encoder cable
CAUTION
Generally use the encoder cable available as our options. If the required length is not found in the
options, fabricate the cable on the customer side.
When fabricating an encoder cable, use the recommended wires given in Section 13.2.1 and the MR-
ECNM connector set for encoder cable fabrication, and fabricate an encoder cable as shown in the
wiring diagram.
Refer to section 14.5 and choose the encode side connector according to the servo motor installation
environment.
(a) MR-EKCBL M-L (standard flex life model)
These encoder cables are used with the HC-KFE series servo motors.
1) Model explanation
Model: MR-EKCBL
2) Connection diagram
For the pin assignment on the servo amplifier side, refer to Section 3.3.1.
Servo amplifier
Encoder cable
(option or fabricated)
CN2
If you have fabricated the encoder cable, connect it correctly.
Otherwise, misoperation or explosion may occur.
POINT
The encoder cable is not oil resistant.
Refer to Section 12.4 for the flexing life of the encoder cable.
When the encoder cable is used, the sum of the resistance values of the
cable used for P5 and the cable used for LG should be within 2.4 .
When soldering the wire to the connector pin, insulate and protect the
connection portion using heat-shrinkable tubing.
When using the encoder cable of four-wire type communication system,
set "1 " in parameter No. 20 to select the four-wire type.
M-L
Symbol Cable Length [m(ft)] Communication System
2 (6.56)
2
5 5 (16.4)
10 (32.8)
10
20 (65.6)
20
30 (98.4)
30
Note: Set "1 " in parameter No. 20.
supplied to servo motor
Encoder connector
50m(164.0ft) max. 30cm
(0.98ft)
Standard flex life
Two-wire type
(Note) Four-wire type
Encoder cable
Encoder connector
Servo motor
172161-9 (AMP)
1
MR
Encoder
4
MD
7
P5E
13 - 9
2 3
MRR
5 6
MDR CONT
8 9
P5G SHD