Upgrade Fpga-Image - Dell Force10 S4810P Reference Manual

upgrade fpga-image

You can use this command can only on systems with SFM3 modules (and only when required by the upgrade procedure
in the release notes). Upgrade the FPGA version in the specified E-Series SFM3 and automatically initiate an automatic
reset to complete the version upgrade.
E-Series, Z-Series
Syntax upgrade fpga-image {sfm} {all | id} [booted | flash:// | ftp: |
slot0: | tftp] file-url
Parameters
sfm
all
id
booted
file-url
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.0.0.0
Version 8.3.1.0
Version 7.5.1.0
Example
FTOS#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
FTOS#
Usage Reset the card using the power-cycle option after restoring the FPGA command.
Information
98
Enter the keyword sfm to upgrade the FPGA on the SFMs.
Enter the keyword all to upgrade the FPGA on all the SFMs.
Enter the keyword id to upgrade the FPGA on all a specific SFM.
Enter the path to the upgrade source. Entering <CR> updates the
FPGA from the flash.
Enter the following location keywords and information to upgrade the
FPGA using an FTOS image other than the one currently running:
• To specify an FTOS image on the internal flash, enter
flash:// file-path/filename.
• To specify an FTOS image on an FTP server, enter ftp://
user:password@hostip/filepath.
• To specify an FTOS image on the external flash on the
primary RPM, enter slot0://file-path/filename.
• To copy a file on a TFTP server, enter tftp://hostip/
filepath/ filename where hostip is either an IPv4
dotted decimal address or an IPv6 URI [x:x:x:x::x] format
address..
Introduced on the Z-Series.
Added the rpm option.
Introduced on the C-Series.