7
8
DCBX Commands
The following DCBX commands are supported on the S4810 platform.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
S4810
Syntax
advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-tlv
iscsi command.
Defaults
Enabled
Command Modes
PROTOCOL LLDP
Command History
Version 8.3.12.0
Version 8.3.16.0
Usage
You can configure iSCSI TLVs to send either globally or on a specified interface. The interface
Information
configuration takes priority over global configuration.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to DCBX peers.
S4810
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-tlv
{fcoe | iscsi} command.
Parameters
{fcoe | iscsi}
Defaults
Application priority TLVS are enabled to advertise FCoE and iSCSI.
Command Modes
PROTOCOL LLDP
624
-
-
Introduced on the S4810.
Introduced on MXL 10/40GbE Switch IO Module.
Enter the application priority TLVs, where:
•
fcoe: enables the advertisement of FCoE in application
priority TLVs.
•
iscsi: enables the advertisement of iSCSI in application
priority TLVs.
-
-