Module Power-Off - Dell Force10 S4810P Reference Manual

Usage Use this command only to configure an empty slot or a slot in which you have hot-swapped a 4-
Information port 40GE line card. Before you insert a different line-card type into a slot pre-configured for a
4-port 40GE line card, be sure to enter the no linecard number command.
On a 4-port 40GE line card, there are six ports and two port pipes (0 and 1). Each port pipe
consists of three ports, one CFP port and two QSFP ports:
To configure linerate mode, specify one port on each pipe. To configure oversubscribed mode,
specify two ports on each pipe.
Example
FTOS(conf)# linecard 5 EX04PJ oversubscribed active-ports port-
set0 1 2
port-set1 0 1
FTOS(conf)# linecard 13 EX04PH linerate active-ports port-set0
2 port-set1 0
FTOS(conf)# linecard 5 EX04PJ linerate active-ports port-set0
1 port-set1 1
Updating the linecard mode or active-ports will require a
linecard reboot.
Proceed with reset of linecard? [confirm yes/no]:
Related show linecard
Commands

module power-off

Turn off power to a line card at next reboot.
C-Series, E-Series
Syntax module power-off linecard number
Parameters
linecard
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.1.1.2
Version 8.1.1.0
Version 7.5.1.0
132
WARNING: After you enter the linecard command to reconfigure a 4-port 40GE line
card installed in an ExaScale switch, you are prompted to reboot the line card to activate
the settings. Traffic on the line card is interrupted when you reset the card.
• Ports 0, 1, and 2 use pipe 0.
• Ports 3, 4, and 5 use pipe 1.
– displays the line card(s) status.
number
Enter the keyword linecard followed by the line card slot number.
The C-Series range is 0 to 7. The E-Series range is 0 to 13 on the
E1200/1200i, 0 to 6 on the E600/E600i, and 0 to 5 on the E300.
Introduced on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale E1200i.
Introduced on the C-Series.