Show Cam-Acl - Dell Force10 S4810P Reference Manual

Version 6.5.1.0
Version 6.3.1.0
Usage You must save the running configuration using the copy running-config startup-
Information config command after changing the CAM profile from CONFIGURATION mode. CAM profile
changes take effect after the next chassis reboot.

show cam-acl

Display the details of the CAM profiles on the chassis and all line cards.
C-Series, Z-SEries, S4810
Syntax show cam-acl
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Usage The display reflects the settings implemented with the cam-acl command.
Information
Example (Default)
FTOS#show cam-acl
-- Chassis Cam ACL --
L2Acl
Ipv4Acl
Ipv6Acl
Ipv4Qos
L2Qos
L2PT
IpMacAcl
VmanQos
VmanDualQos:
Ipv4pbr
-- Line card 4 --
L2Acl
Ipv4Acl
Ipv6Acl
Ipv4Qos
L2Qos
576
Added the eg-default and ipv4-320k CAM profiles.
Introduced on the E-Series.
NOTE: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
NOTE: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes
lead to unexpected behavior. After you reload the chassis, you may make changes to the
IPv4 Flow partition.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series.
Current Settings(in block sizes)
: 6
: 5
: 0
: 1
: 1
: 0
: 0
: 0
0
: 0
Current Settings(in block sizes)
: 6
: 5
: 0
: 1
: 1