Cam Ipv4Flow Commands; Cam Ipv4Flow (Exec Privilege); Cam-Ipv4Flow (Configuration) - Dell Force10 S4810P Reference Manual

102|
FTOS#

CAM IPv4flow Commands

IPv4Flow sub-partitions are supported on the E-Series TeraScale platform.
The 18-megabit user-configurable CAM is divided into multiple regions such as Layer 2 FIB, Layer 3 FIB, IPv4Flow, IPv4
Ingress ACL The IPv4Flow region is further subdivided into five regions: System Flow, QoS, PBR, Trace-lists, Multicast
FIB & ACL.
You can change the amount of CAM space allocated to each sub-region. You can configure the IPv4Flow region in
TeraScale.
Like CAM profiles, you can configure the IPv4Flow region from EXEC Privilege and CONFIGURATION mode.

cam ipv4flow (EXEC Privilege)

Configure the amount of CAM space in the IPv4flow sub-regions.
NOTE: This command is deprecated as of FTOS version 8.3.1.0.
TeraScale
Syntax cam ipv4flow {chassis all | linecard number} {default | acl
value multicast-fib value pbr value qos value system-flow value
trace-list value}
Command Modes EXEC Privilege
Command History
Version 8.3.1.0
Version 6.3.1.0

cam-ipv4flow (CONFIGURATION)

Configure the amount of CAM space in IPv4flow sub-regions.
TeraScale
Syntax cam-ipv4flow {default | multicast-fib value pbr value qos value
system-flow value trace-list value}
Parameters
default
multicast-fib
value
584
0|Allowed
COMMAND DEPRECATED
Introduced on the E-Series.
Enter the keyword default to reset the IPV4Flow CAM region to its
default setting.
Enter the keywords multicast-fib followed by the number of
entries for the multicast FIB sub-region in 1K increments. The range is
1 to 32 KB. The default is 9 KB.