Show Redundancy - Dell Force10 S4810P Reference Manual

show redundancy

Display the current redundancy configuration.
C-Series, E-Series, S4810
Syntax show redundancy
Command Modes
Command History
Version 8.3.12.0
Version 8.1.1.0
Version 7.5.1.0
Version 7.6.1.0
Usage The following describes the show redundancy command shown in the Example below.
Information
Field
RPM Status
PEER RPM Status
RPM Redundancy
Configuration
RPM Failover Record Displays the following information:
734
• EXEC
• EXEC Privilege
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the following information:
•
•
•
•
Displays the state of the second RPM, if present
Displays the following information:
•
•
•
•
•
•
Slot number of the RPM.
Whether the RPM is Primary or Standby.
The state of the RPM: Active, Standby, Booting, or Offline.
Whether the link to the second RPM is up or down.
which RPM is the preferred Primary on next boot (the
redundancy primary command)
the data sync method configured (the redundancy
synchronize command)
the failover type (you cannot change this type; it is software-
dependent). Hot Failover means that the running
configuration and routing table are applied on secondary
RPM. Fast Failover means that the running configuration is
not applied on the secondary RPM until failover occurs, and
the routing table on line cards is cleared during failover.
the status of auto booting the RPM (the redundancy
disable-auto-reboot command)
the parameter for auto failover limit control (the
redundancy auto-failover-limit command)