Show Interfaces - Dell Force10 S4810P Reference Manual

Version 6.1.1.0
Example
FTOS(conf)#interface range gigabitethernet 1/1 - 2
FTOS(conf-if-range-gi-1/1-2)#show config
!
interface GigabitEthernet 1/1
!
interface GigabitEthernet 1/2
FTOS(conf-if-range-gi-1/1-2)#

show interfaces

Display information on a specific physical interface or virtual interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show interfaces interface
Parameters
interface
Command Modes
788
Introduced on the E-Series.
no ip address
switchport
no shutdown
no ip address
switchport
no shutdown
Enter one of the following keywords and slot/port or number
information:
•
•
•
•
•
•
•
•
•
•
• EXEC
For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
For the management interface on an RPM, enter the keyword
ManagementEthernet followed by the slot/port
information. The slot range is 0 to 1 and the port range is 0.
For a Null interface, enter the keywords null 0.
For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/port.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For a VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.