Ip Igmp Static-Group - Dell Force10 S4810P Reference Manual

ip igmp static-group

Configure an IGMP static group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp static-group {group address [exclude [source address]]
| [include {source address}]}
To delete a static address, use the no ip igmp static-group {group address
[exclude [source address]] | [include {source address}]} command.
Parameters
group address
exclude
address
include
address
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
A group in include mode must have at least one source address defined. In exclude
Information
mode, if you do not specify a source address, FTOS implicitly assumes all sources are included.
If you do not specify either include or exclude, FTOS implicitly assumes a IGMPv2 static
join.
Command Limitations
Related show ip igmp groups
Commands
746
Enter the group address in dotted decimal format (A.B.C.D).
source
(OPTIONAL) Enter the keyword exclude followed by the source
address, in dotted decimal format (A.B.C.D), for which a static entry
needs to be added.
source
(OPTIONAL) Enter the keyword include followed by the source
address, in dotted decimal format (A.B.C.D), for which a static entry
needs to be added.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Expanded to support the exclude and include options.
• Only one mode (include or exclude) is permitted per multicast group per
interface. To configure another mode, all sources belonging to the original mode must
be unconfigured.
• If a static configuration is present and a packet for the same group arrives on an
interface, the dynamic entry completely overwrites all the static configuration for the
group.
– displays IGMP group information.