Dell Force10 S4810P Reference Manual page 274

log
order
monitor
fragments
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.3.11.1
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.10
Usage
The order option is relevant in the context of the Policy QoS feature only. For more
Information
information, refer to the "Quality of Service" chapter of the
When you use the log option, the CP processor logs details about the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets' details.
The C-Series and S-Series cannot count both packets and bytes; when you enter the count
byte options, only bytes are incremented.
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators
(for example, gt, lt, or range) may require more than one entry. The range of ports is configured
274
(OPTIONAL, E-Series only) Enter the keyword log to have the
information kept in an ACL log file.
(OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower order numbers have a higher priority). If
you do not use the keyword order, the ACLs have the lowest order
by default (255).
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the
Guide .
Enter the keyword fragments to use ACLs to control packet
fragments.
Introduced on the Z9000.
Added the keyword dscp.
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for non-contiguous mask and added the monitor
option. .
Expanded to include the optional QoS order priority for the ACL
entry.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
Port Monitoring.
FTOS Configuration
FTOS Configuration Guide .