Linecard - Dell Force10 S4810P Reference Manual

Parameters
aux 0
console 0
vty
end-number
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Usage You cannot delete a terminal connection.
Information
Related
access-class
Commands
control list (ACL).
password
show linecard

linecard

Pre-configure a line card in a currently empty slot of the system or a different line card type for the slot. To pre-configure
a 4-port 40G line card, refer to the linecard command.
C-Series, E-Series
Syntax linecard number card-type
Parameters
number
Enter the keyword aux 0 to configure the auxiliary terminal
connection.
NOTE: This option is supported on E-Series only.
Enter the keyword console 0 to configure the console port. The
console option for the S-Series is <0-0>.
number
Enter the keyword vty followed by a number from 0 to 9 to configure
a virtual terminal line for Telnet sessions. The system supports 10
Telnet sessions.
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line
to configure. You can configure multiple lines at one time.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
– restricts the incoming connections to a particular IP address in an IP access
– specifies a password for users on terminal lines.
– displays the line card(s) status.
Enter the number of the slot. For the C-Series, the range is 0 to 7. For
the E-Series, the range is 0 to 13 on the E1200/E1200i, 0 to 6 on the
E600/E6001, and 0 to 5 on the E300..
129