Dell Force10 S4810P Reference Manual page 583

---------------------------------------------------------------
--------
232|
0|
FTOS#
FTOS#test cam-usage service-policy input LauraMapTest linecard
2 port-set 1
Linecard|Portpipe|CAM Partition|AvailableCAM|EstimatedCAM per
Port|Status
---------------------------------------------------------------
-------
232|
0|
FTOS#
Usage
The following describes the test cam-usage command shown in the Example below.
Information
Term
Stack-Unit
Portpipe
CAM Partition
Available CAM
Estimated CAM per
Port
Status
Example (S-
FTOS#test cam-usage service-policy input LauraIn stack-unit all
Series)
Stack-Unit|Portpipe|CAM Partition|AvailableCAM|EstimatedCAM
per Port|Status
---------------------------------------------------------------
---------
102|
102|
FTOS#
!
FTOS#test cam-usage service-policy input LauraIn stack-unit 0
port-set 1
Stack-Unit|Portpipe|CAM Partition|Available CAM|EstimatedCAM
per Port|Status
---------------------------------------------------------------
-----------
4| 0| IPv4Flow|
0|Allowed
4| 0| IPv6Flow|
0|Allowed
2| 1| IPv4Flow|
0|Allowed
2| 1| IPv6Flow|
0|Allowed
Explanation
Lists the stack unit or units that are checked. Entering all shows
the status for all stacks.
Lists the portpipe (port-set) or port pipes (port-sets) that are
checked. Entering all shows the status for linecards and port-pipes
in the chassis.
Shows the CAM profile of the CAM.
Identifies the amount of CAM space remaining for that profile.
Estimates the amount of CAM space the listed policy will require.
Indicates whether or not the policy will be allowed in the CAM.
0| 0|
0|Allowed
0| 1|
0|Allowed
0| 1|
IPv4Flow|
IPv4Flow|
IPv4Flow|
583