Dial Plan; User Tab - Linksys SPA922 Administrator's Manual

Since two G.723.1/G.726 resources are available per SPA9x2, you should disable the use of
G.729a to guarantee support for two simultaneous G.723/G.726 codecs.

Dial Plan

The default dial plan script for each line is as follows: (*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-
9]xxxxxx|xxxxxxxxxxxx.). For more information, see
Parameter
Dial Plan
Enable IP Dialing

User Tab

This section describes the fields for the following headings on the User tab:
Linksys SPA9x2 Phone Administration Guide
SPA9x2 Phone Field Reference
Appendix B "Configuring a Dial
Description
Dial plan script for this line.
The dial plan syntax is expanded in the SPA to allow the
designation of three parameters to be used with a
specific gateway:
• uid – the authentication user-id
• pwd – the authentication password
• nat – if this parameter is present, use NAT
mapping
Each parameter is separated by a semi-colon (;).
Furthermore, it recognizes gw0, gw1, ..., gw4 as the
locally configured gateways, where gw0 represents the
local PSTN gateway in the same unit.
Example 1:
*1xxxxxxxxxx<:@fwdnat.pulver.com:5082;uid=jsmith;pwd=
xyz
Example 2:
*1xxxxxxxxxx<:@fwd.pulver.com;nat;uid=jsmith;pwd=xyz
Example 3:
[39]11<:@gw0>
Enable or disable IP dialing.
Defaults to no.
Cisco Confidential--First Draft
User Tab
Plan".
175