Configuring The Spa932 - Linksys SPA922 Administrator's Manual

Configuring the SPA932

Complete the configuration required for the extensions on your IP PBX and obtain the
following information:
• SPA9000 IP address or other hostname
• Phone extension numbers
To configure the SPA932:
1. Connect to the web UI for the SPA962 to which the SPA932 is connected.
2. Click Admin/Advanced on the web UI page.
3. Click the SIP tab.
4. Select yes from the CTI Enable drop-down list.
5. Click the SPA932 tab. (If you do not see the SPA932 tab, check your firmware version, and
upgrade as necessary.)
The system displays the SPA932 web page.
6. Select yes from the Unit 1 Enable drop-down list. If you have installed two SPA932 units, also
select yes from the Unit 2 Enable drop-down list.
7. Select your Server Type from the drop-down list:
– SPA9000
– Broadsoft
– Asterisk
8. Make sure that no is selected for Test Mode Enable. This option is disabled by default. You
cannot complete the software configuration for the SPA932 if this option is enabled. (You
can use Test Mode Enable later to test the SPA932.)
Linksys SPA9x2 Phone Administration Guide
Using the SPA932 Sidecar
Setting Up the SPA932 Sidecar
117