Configuring A Dial Plan - Linksys 900 Series Administrator's Manual

Chapter 3 Managing Linksys 900 Series IP Phones
Only TFTP is supported. If the host is not specified, the TFTP host is the web client. The
default port is 69. To remove the User 1 ring tone from the phone, set the <path> to delete, as
follows:
http://phone_ip_addr/ringtone1?/delete
The link is case sensitive.
For ring tone User 1 and User2, the cadence is fixed with the on-time equals to the duration of
the ring tone file and off-time equals to four seconds. The total ring duration is fixed at 60
seconds. The user ring tone names displayed on the phone LCD are derived from the ring tone
file header file.
There is no need to reboot the phone after downloading a ring tone. However, if the phone is
already in ring tone LCD menu while the new ring tone is downloaded, you need to exit and
re-enter the ring tone menu to see the new ring tone name on the menu.
To convert a file for use as a ringtone, use the Upload Ringtone utility available from the
Linksys website:
http://www.sipura.com/Documents/ringtone.zip
Figure 3-7
Figure 3-7
For input, you can use any .wav file less than eight seconds.

Configuring a Dial Plan

The 900 Series phone allows each line to be configured with a distinct dial plan. The dial plan
specifies how to interpret digit sequences dialed by the user, and how to convert those
sequences into an outbound dial string.
The 900 Series phone syntax for the dial plan closely resembles the corresponding syntax
specified by MGCP and MEGACO. Some extensions are added that are useful in an end-point.
Document Version 3.1
illustrates the user interface provided by this utility.
Upload Ringtone Utility
Linksys 900 Series IP Phone Administrator Guide
Configuring a Dial Plan
3-25