Enabling Remote Voice Mail Access (Optional) - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Configuring Phone Service and Voice Mail

Enabling Remote Voice Mail Access (Optional)

Enabling Remote Voice Mail Access (Optional)
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
SPA9000 Voice System Installation and Configuration Guide for Web UI
Mail Users," on page
Each Station," on page
•
Busy Tone: A busy tone indicates a problem with the configuration. Verify
that the USB drive is properly inserted into the SPA400. Verify that the
correct data was entered on the SPA9000 > Line 2 configuration page (see
"Configuring SPA9000 Connectivity with the SPA400 for PSTN and Voice
Mail Service," on page
SPA400 (see "Configuring the Voice Mail Server and Voice Mail Users," on
page 82) and that the correct line and mailbox were entered on the Phone
configuration page (see
Follow this procedure to allow users to access their voice mail remotely.
If your users will call into your voice mail system through an ITSP line, your ITSP
must support out-of-band DTMF.
Start Internet Explorer, and then enter the IP address of the SPA9000. Click Admin
Login and then click Advanced.
Click Voice > SIP.
Auto Attendant Parameters
Scroll down to the
AA Dial Plan 1
Edit the
described below.
•
SYNTAX: (10x | xxx. | <dialcode:vmmN>)
•
EXAMPLE: (10x | xxx. | <8:vmm2>)
•
dialcode: The digit that users dial, when prompted by the Auto Attendant, to
access voice mail remotely.
82) and the Phone configuration page (see
85).
70). Verify that the mailbox was set up on the
"Setting Up Each Station," on page
string to include a code for the voice mail server, as
85).
section.
5
"Setting Up
88