Configuring Phone Service and Voice Mail
Configuring the SPA400
STEP 5
STEP 6
STEP 7
SPA9000 Voice System Installation and Configuration Guide for Web UI
Restart the SPA400 by completing the following steps:
a. Click Administration tab > Reboot.
b. Click Restart System.
c. When the confirmation message appears, click OK. The SPA400 reboots.
Reboot OK. Go to Setup Page?
d. When the
To verify your progress, click the Status tab, and verify the following settings:
a. USB status: Mount
b. Voice mail status: OK
c. SPA9000 Registration status: Registered
If the SPA registration status is not Registered, disconnect power to the
NOTE
SPA9000 and then reconnect power after a short wait. After the SPA9000
and the phones reboot, click Refresh on the SPA400 Status page.
Continue to the next procedure,
message appears, click OK.
"Setting Up Each Station," on page
5
85.
84