Configuring Spa9000 Connectivity For Pstn Access Only - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Configuring Phone Service and Voice Mail
Configuring the SPA9000
NOTE
STEP 1
STEP 2
STEP 3
SPA9000 Voice System Installation and Configuration Guide for Web UI

Configuring SPA9000 Connectivity for PSTN Access Only

You can configure the SPA9000 so that the users can place and receive calls
through PSTN lines that are connected to a SPA400, or to multiple SPA400
devices. Set up a line interface for each SPA400 that you connect.
This step is required if you want to configure another SPA400 for PSTN access only.
Start Internet Explorer, and then enter the IP address of the SPA9000. Click Admin
Login and then click Advanced.
Click Voice tab > Line 3.
Any line can be used; however, for consistency throughout this Install Guide,
NOTE
Line 1 is used for ITSP service, Line 2 is used for the SPA400 that has voice
mail service, and Line 3 is used for a second SPA400 that has PSTN access.
Enter the following information about the SPA400:
•
User ID: 9000
This ID corresponds to the User ID that you entered on the SPA400
configuration page. They must match exactly.
•
Proxy: Enter the IP address of the SPA400.
5
74