Setting Up The Wan Connection For The Spa9000 - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Installing the SPA9000
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI
You may need to refresh your browser to display the updated page
NOTE
reflecting the new version number.

Setting Up the WAN Connection for the SPA9000

The SPA9000 becomes a DHCP client of any server on the network. The
recommended setting is to use a static IP address. This configuration provides
ease of installation and prevents connectivity issues that would occur if the IP
address of the SPA9000 changed.
Start Internet Explorer, and enter the IP address of the SPA9000. The
Status
page appears. By default, the page is in Basic User mode.
Log on to the administrator view by clicking Admin Login, near the top right corner
of the page. Then click Advanced.
By default, no password is required. You can assign an administrative
NOTE
password later, but it is convenient not to use a password during the initial
configuration.
Click Router tab > Wan Setup.
Connection Type
From the
In the Static IP Settings
NetMask Gateway
and
SPA9000 Router tab > Wan Setup page: Static IP Settings section
drop-down list, choose Static IP.
area, enter the Static IP of the SPA9000, as well as the
for your network.
4
Router >
51