Connecting The Spa9000 - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Connecting the Equipment
Installing the SPA9000
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI

Connecting the SPA9000

Follow this procedure to connect your SPA9000 to your switch.
Connect an analog phone to the Phone 1 port of the SPA9000.
An analog phone is required for use with administrative Interactive Voice
NOTE
Response module. It also can be used as an extension number.
Optionally, connect a second analog telephone or fax machine directly to the
Phone 2 port or run cable from Port 2 to a phone that is located elsewhere in the
office.
Connect a network cable to the INTERNET port (blue) of the SPA9000. Connect
the other end of the cable to an available port on your switch.
IMPORTANT: Do not connect any cable to the ETHERNET port of the
NOTE
SPA9000. The SPA9000 is connected to the LAN switch only through the
INTERNET port (blue).
Connect the included power cord to the POWER port of the System, and then
connect the power adapter to an electrical outlet.
The Power LED turns red and then green, and then the SPA9000 begins the boot
process.
•
If you would like to provide SPA9000 with Power over Ethernet support, you
can connect/use POES5 Power over Ethernet adapter.
•
If the SPA9000 has been used previously, reset it to the factory defaults before
you proceed to the other steps in the configuration process. See
reset the SPA9000 (if needed)," on page
After the reboot process is completed, start Internet Explorer, and enter the default
IP address of the SPA9000: 192. 1 68.0. 1 09
If the system is properly installed, the
properly powered and has successfully initialized.
48.
Info page appears. Your SPA9000 is
4
"To factory
47