Installing the SPA9000
This section explains how to connect the SPA9000 to your switch, to administer it with an analog
phone and a computer, to upgrade the firmware, and to set up the WAN connection .
SLM224P Ethernet Switch
SPA9000
IP PBX
NOTE:
This illustration depicts only the devices that are connected at this stage in the installation .
This section includes the following topics:
"Connecting the SPA9000" on page 31
•
"Upgrading the Firmware for the SPA9000" on page 32
•
"Setting Up the WAN Connection for the SPA9000" on page 35
•
Connecting the SPA9000
Follow this procedure to connect your SPA9000 to your SLM224P switch .
1 .
Connect an analog phone to the Phone 1 port of the SPA9000 .
NOTES:
An analog phone is required for use with administrative Interactive Voice Response
module . It also can be used as an extension number .
2 .
Optionally, connect a second analog telephone or fax machine directly to the Phone 2 port or run
cable from Port 2 to a phone that is located elsewhere in the office .
3 .
Connect an Ethernet network cable to the Ethernet port (yellow) of the SPA9000 . Then connect
the other end of the cable to the Ethernet switch .
4 .
Connect an Ethernet network cable to the
end of the cable to one of the ports on your SLM224P switch .
5 .
Connect the included power cord to the
adapter to an electrical outlet .
NOTE:
If you would like to provide SPA9000 with Power over Ethernet support, you can connect/
use POES5 Power over Ethernet adapter .
Linksys Voice System Installation and Configuration Guide
Connecting the LVS Equipment
Analog
Power
Phone (IVR)
Internet port (blue) of the SPA9000 . Connect the other
Power port of the System, and then connect the power
Installing the SPA9000
Internet Integrated
Router
Access Device
Admin.
PC
31