Table of Contents
Advertisement
Interface
Administrator
Honeywell IP Utility
•
•
•
•
•
Web-Client*
•
•
•
* The features available on the Web-Client depend on whether it is a fixed or PTZ dome.
Confirming Your System Requirements
Document 800-04195 Rev B
11/09
Table 3-1
User Profiles for Honeywell IP Utility and Web-Client
View the list of devices available and
connect to the devices
Configure the IP network settings
Upgrade firmware
Change the password to access the
IP Utility application
Change the access passwords to the
Web-Client application
View video and network settings, start
presets and tours
Configure presets, tours, sectors, and
privacy zones, video analytics and
Codec parameters
Enable NightShot and backlight
modes, and use the Flashback
function (camera dependent)
Note
Windows administrator privileges are required to install the Honeywell IP
Utility and associated software.
Note
Contact the network administrator if there are any questions regarding the
local area network (LAN) or any other network related issues.
Install the Honeywell IP Utility on a work station with the minimum requirements in
Table
3-2. After the IP Utility is installed, the same computer work station can be used to
access the Web-Client.
Table 3-2
PC Minimum System Requirements
Component
Operating System
Processor
RAM
Web Browser
HNVE1 V2.1 1-Channel Encoder Reference Guide
Guest
•
View the list of devices available on the
network
•
View system settings, including device
name, IP address, and MAC address
•
Guest users are limited to the Live View
tab where they can view video, select
presets, and start tours
•
Configure up to four presets while
viewing video
•
Enable NightShot and backlight modes
and use the Flashback function (camera
dependent)
Requirement
Windows XP® or WINServer 2003
®
®
Intel
Pentium
IV, 2.4 GHz or faster
512 MB or higher
Microsoft® Internet Explorer®, V6.0 or later
29
Advertisement
Table of Contents
Troubleshooting
