Video Termination; Figure 5-2 Device Configuration On Device Setup Tab - Honeywell HNVE1 Reference Manual

Video Termination

Document 800-04195 Rev B
11/09
Figure 5-2 Device Configuration on Device Setup Tab
Video termination is supported to optimize video quality.
If you are using the video loopback function, then connect the video source to the video
input port to receive analog video in the output port. Set video configuration to Disable.
If you are not using the video loopback function, then connect the video source to the video
input port, and then set video termination to Enable.
To enable the video termination option:
1. Click the Device Information tab.
2. Set Video Termination to Disable if you are using the video loopback function.
OR
Set Video Termination to Enable if you are not using the loopback function.
3. Click Apply.
HNVE1 V2.1 1-Channel Encoder Reference Guide
61